Dake V-16 Manual de instrucciones Pagina 9

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 24
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 8
4/11/2007 9
The blade should always be inspected before installing on the machine. Things to look for should
be the smoothness on the sides and back edge of the weld, look for any missing teeth, or impacted
chips. The blade guides may now be selected and inserted into both the upper and lower guide
holders. Proper adjustment of these guides takes place when they form a complete “V” shape (see
graphic above) and support the blade equally on each side. A couple of thousands on each side of
the blade will provide the running clearance and support for contour sawing.
Note: Chips should be removed from the blade guides during each blade change or
more frequently if required.
BLADE GUIDES
The back end roller that supports the back of the blade on each guide holder contains a hardened
cap over a set of ball bearings. This should be checked periodically for free movement so it is
allowed to rotate freely as the back of the blade comes in contact with the face of this roller.
Noticeable friction in this assembly indicates it should be replaced. This can be done by removing
the right hand guide insert, moving the left hand guide up away from the bearing face. Loosen the
setscrew on the bottom of the guide holder and sliding the old bearing and shaft out and a new one
in. Tighten the setscrew and re-adjust the guides. See graphic below.
The “V” type solid blade guides and holder assemblies as furnished standard with the machine and
are recommended for the majority of cutting applications.
BAND SPEED SELECTION
The saw blade is driven by a direct drive transmission. On the front panel you will see the surface
feet per minute read out (see chart for proper blade selection).
Vista de pagina 8
1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 23 24

Comentarios a estos manuales

Sin comentarios